Replacing the gas-block gasketUpdated 2 months ago

Here is an instructional video: How to check and replace the gasket on Carbonator 3

1. Remove the drip tray cover.

2. Each Carbonator has an extra gasket stored under the base of the machine, underneath a sticker labelled "Extra Gasket." Remove the sticker and take out the extra gasket.

3. Ensure that the CO2 cylinder has been removed from the Carbonator.

4. A round 2 cm/1in below the black seam, there is a screw at the back of the machine. Unscrew it using a Phillips-type screwdriver, grab the upper part of the machine, and lift it out from the body.

5. Turn the upper portion upside down and look inside. If necessary, remove the old gasket with tweezers or a small screwdriver. Place the new gasket into the circular hole and push it into place around the entire perimeter.

6. Place the upper portion of the machine back into the main body. Ensure it's straight and facing the correct direction before screwing it back in. 

7. Enjoy your sparkling water again!